Pair of Crossover PCBs for the Hitmaker MT DIY speaker design - PCB Kit

Description

Custom printed circuit boards designed for the crossover of the Hitmaker MT DIY speaker design by Paul Carmody.
Take the guesswork out of crossover assembly, these boards make the process quick and straightforward.
The boards measure 5.5" x 3.25" and feature large solder pads and copper traces for great electrical connectivity.
Note photos of fully assembled crossovers are for reference only.
Includes:
2x Crossover PCBs for the Hitmaker MT DIY speaker design.
6x Terminal blocks which accept up to 12 gauge wire.
8x Snap in PCB standoffs.
8x Mounting screws (screw finish may vary).
Requires:
Crossover components for the Hitmaker MT speaker design.
Compatible components tested for fit on this PCB:
C1 - 6.8uF - Dayton Audio DMPC-6.8
C2 - 0.22uF - Dayton Audio DMPC-0.22
C3 - 8.2uF - Dayton Audio DMPC-8.2
L1 - 0.40mH - Jantzen Audio 0.40mH 20 AWG Air Core
L2 - 2.0mH - Jantzen Audio 2.0mH 18 AWG Air Core
R1 - 8 Ohm - Dayton Audio DNR-8.0
R3 - 2.4 Ohm - Dayton Audio DNR-2.4
Assembly:
Glue components to the correct positions on the board (hot melt glue works great). Secure inductors with non metallic cable ties. Solder components leads to the pads on the bottom of the board. Attach wires from input and drivers and mount crossover board.