Pair of Crossover PCBs for the TriTrix DIY speaker design - PCB Board Kit

Description

Custom printed circuit boards designed for the crossover of the TriTrix speaker design by Curt Campbell.
These boards work with both the MT and MTM versions of the TriTrix in either the Vented or Transmission Line enclosure design.
The boards measure 6.2" x 3.15" and feature large solder pads and copper traces for great electrical connectivity
Note photos of fully assembled crossovers are for reference only.
The photos of the assembled crossover are of a TriTrix MT Crossover.
Includes:
2x Crossover PCBs for the TriTrix speaker design.
6x Terminal blocks which accept up to 12 gauge wire.
8x Snap in PCB standoffs.
8x Mounting screws (screw finish may vary).
Requires:
Crossover components for the TriTrix MT or MTM speaker design.
Compatible components for the Tritrix MT tested for fit on this PCB:
C1021 - 20uF - Dayton Audio DMPC-20
C2021 - 8.2uF - Dayton Audio DMPC-8.2
L1011 - 1.3mH - Jantzen Audio 1.3mH 18 AWG Air Core
L2031 - 0.30mH - Jantzen Audio 0.30mH 20 AWG Air Core
L2041 - 0.05mH - Jantzen Audio 0.05mH 18 AWG Air Core
R2011 - 2.2 Ohm - 2.2 Ohm 10W Resistor Wire Wound
Compatible components for the Tritrix MTM tested for fit on this PCB:
C1021 - 20uF - Dayton Audio DMPC-20
C2021 - 10uF - Dayton Audio DMPC-10
L1011 - 2.5mH - Jantzen Audio 2.5mH 18 AWG Air Core -or- ERSE 2.5mH 18 AWG Perfect Layer Inductor Crossover Coil
L2031 - 0.60mH - Jantzen Audio 0.60mH 18 AWG Air Core -or- ERSE 0.60mH 18 AWG Perfect Layer Inductor Crossover Coil
L2041 - Bypassed
R2011 - 2.4 Ohm - Dayton Audio DNR-2.4
Assembly:
Glue components to the correct positions on the board (hot melt glue works great). Secure inductors with non metallic cable ties. Solder components leads to the pads on the bottom of the board. Attach wires from input and drivers and mount crossover board.